I searched for this and found a couple posts, but just want to be sure...I have Stage 1 PCM, and will be getting the UEGO in a week. I'm wondering where to put the new sensor---after the cat (still have stock 02 housing and cat) i/e the "second" 02 sensor, as it's no longer monitored by Stage 1? Is this correct?

__________________
STG 1 PCM, Borla Cat Back, Maddog 58%, MSD Wires, K&N CAI w/ PTP Splash Shield, WG, Check Valve, Fuel Pump Rewire, GReddy OCC and TT, AGP Bones and Trans Mount, 180 Stat, Walbro 255, DTEC FC, AEM UEGO, MAXXFAB 3" O2 Housing and Hi-Flow Cat

correct!

__________________
My Srt4
13.19 @ 106 2.04 (60) on street tires
12.85 @ 105 1.88 (60) on slicks
^^Ha got the Charger beat^^

My mopar 528ci S & W Dragster
7.59 @ 187 1.08 (60) big slicks DUH

Parents Srt8 Charger
12.98 @ 108 1.97 (60) on street tires

it will still throw a code if the downstream is not heated...and placing the wideband sensor after the cat will give you false readings.

__________________
At least my neon makes more than 350ft/lbs

heat doesn't matter but it does have to stay pluged up to the wire harness so just unscrew it from the cat and tie it up out of the way. The readings are fine because its not really after the cat its right at the front of it. You should get 14.7 at idle.

__________________
My Srt4
13.19 @ 106 2.04 (60) on street tires
12.85 @ 105 1.88 (60) on slicks
^^Ha got the Charger beat^^

My mopar 528ci S & W Dragster
7.59 @ 187 1.08 (60) big slicks DUH

Parents Srt8 Charger
12.98 @ 108 1.97 (60) on street tires