Dodge Dodge Forum SRT
Dodge Forum Dodge Ram
Dodge Forum   Dodge Classifieds   News   Photo Gallery   Calendar   Search   Contact   Sponsors
Dodge Recalls & TSBs   Dodge Lineup   Dodge Wallpaper   Dodge History   Dodge Timeslips   Member List   Register   Login

Code 32, engine miss HELP

  Printable Version
Dodge Forums >> Dodge Cars >> Dodge Intrepid >> 1st Gen Intrepid >> Code 32, engine miss HELP Page: [1]
Login
Message << Older Topic   Newer Topic >>
Code 32, engine miss HELP - 3/3/2007 6:14:02 PM   
dodgeboy64

 

Posts: 67
Joined: 3/12/2006
Status: offline
Egr code, I replaced the egr valve assembly, and did the upper and lower intake gaskets, as well as 2 of the 4 o2 sensors.  Miss is at high vacuum light throttle.  Plugs, wires, and coilpack , pcv valve are all new.  I'm at a loss as to what may be the problem.  Miss was there before I changed the tranny, but no CEL till after the tranny change.
Post #: 1
RE: Code 32, engine miss HELP - 3/3/2007 10:29:17 PM   
kurts2

 

Posts: 553
Joined: 10/27/2006
Status: offline
You say a code 32, how was that obtained/  is that a P032 from a scan tool, or a MIL 32 from the flashing engine light method?  They both mean diffrent things!

(in reply to dodgeboy64)
Post #: 2
RE: Code 32, engine miss HELP - 3/4/2007 10:12:31 PM   
dodgeboy64

 

Posts: 67
Joined: 3/12/2006
Status: offline
Thanks for the reply, code was obtained from MIL flashing I do have a scan tool but no code book for the car.  It is a 96 es with 3.5v6, 133,000 miles.  I have also changed the Idle control motor.  Miss is worst under light load at about 50 mph.
Brian

(in reply to kurts2)
Post #: 3
RE: Code 32, engine miss HELP - 3/5/2007 10:25:21 AM   
kurts2

 

Posts: 553
Joined: 10/27/2006
Status: offline
I can translate the codes.  There may be more info derived this way, so read them and post them here.  I will let you know.

(in reply to dodgeboy64)
Post #: 4
RE: Code 32, engine miss HELP - 3/5/2007 9:17:51 PM   
dodgeboy64

 

Posts: 67
Joined: 3/12/2006
Status: offline
From my scan tool, code is P0401, which from what I can find is egr function..  Hope this helps.  Thanks again.
Brian

(in reply to kurts2)
Post #: 5
RE: Code 32, engine miss HELP - 3/8/2007 11:47:21 PM   
kurts2

 

Posts: 553
Joined: 10/27/2006
Status: offline
sorry for the long wait, I've been off line... Now for the code, yes, it is EGR flow low.  I hate to say it, but It could be related to the O2 sensor!  Which two have yoy changed? 

(in reply to dodgeboy64)
Post #: 6
RE: Code 32, engine miss HELP - 3/9/2007 11:10:22 PM   
dodgeboy64

 

Posts: 67
Joined: 3/12/2006
Status: offline
I changed the pre and post ones on the left side, I disturbed them when I changed the tranny.  I may have fixed it last night.  I took new egr valve off again to make sure there was no carbon in it, and found gasket for tube running up to intake looked bad.  I sealed it up with some permatex red and put it back together.  So far the cel has stayed out and miss is much better, still a slight one under load.  Thanks for all your help, I plan on changing the other 2 o2 sensors anyway.  Car has 133,000 so it's due.

(in reply to kurts2)
Post #: 7
RE: Code 32, engine miss HELP - 3/11/2007 12:13:22 PM   
kurts2

 

Posts: 553
Joined: 10/27/2006
Status: offline
The slight miss under load, could be a vacume leak (I hear it's common).  Of course it could be lots of other things (dirty injectors, sensor slightly out of range, ect).  Glad to hear your low flow is fixed.  You must have been pumping exhaust gas into the engine compartment and sucking it in for "clean air".  I guess that could account for the EGR low flow causing an engine miss. 

(in reply to dodgeboy64)
Post #: 8
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
 
Dodge >> Dodge Cars >> Dodge Intrepid >> 1st Gen Intrepid
Jump to:



Featured Sponsors
new used
Advertising Info

Poll
Now that you've seen the 2008 Dodge Challenger SRT-8, what do you think?
I Love It, Its Perfect
I love the looks, but hate the transmission
I like it, but I want the concept interior
I like it, but I want the exact concept exterior
Its ok, but the concept was far better
Thanks, but I look forward to some changes on the 2009 models.

Poll Results
Previous Polls

Top 10 Posters
dustyloins21010
badstratrt20740
midnight17435
vipergts14468
dodgegirl1913072
ramfan5.912435
steve05ram3611328
nickoman0110863
drew10116
casper9606

New Vendors
Truxedo
Airaid
Mopar Biz
ATI ProCharger
Motor City Auto Parts
Sonic Electronix
Buy Auto Truck Accessories
Buy Car Floor Mats
Edge Products
AMSOIL - Performance Oil Technology

Harley Davidson | Ford Mustang Forums | Dodge Challenger

Dodge Forum .com is not affiliated with or endorsed by Daimler Chrysler.