Aftermarket product listing for the Stratus Sedan
Login  | |
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 8/30/2005 9:33:43 PM
|
|
|
DarylLampe
Posts: 4
Joined: 8/15/2005
Status: offline
|
I have a 98 Plymouth Breeze, 2.4L. With CAI, custom made 2.5inch CAT back exhaust, and Titanium tip sport muffler. I also have 17inch Primax Silver Powder coated aluminum wheels, and low profile tires. I have installed the Eibach pro kit, which lowers it 1.5inches. I have an APR wing, with carbon fiber ends, and cross drilled and slotted performance brake rotors. I will post a pic as soon as I can.
|
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 9/18/2005 9:19:21 PM
|
|
|
Ice_Man_67
Posts: 125
Joined: 7/3/2005
Status: offline
|
Ok, I got a 95 SOHC 2.0L (5spd), with:
short thow shifter
cold air intake with K&N cone filter
Pacesetter header (ceramic coated) followed by custom 2.5" exhaust with hight flow cat and muffler
MSD coil and wires
55mm bored out Throttle Body with half shaft mod (57mm)
AFX underdrive pulley
< Message edited by Ice_Man_67 -- 2/4/2006 4:27:20 PM >
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 12/8/2005 2:06:51 PM
|
|
|
strat98
Posts: 4
Joined: 12/7/2005
Status: offline
|
i have a 98 strat 2.4 DOHC 16 valve right now i dont have anything done motor wise but this summer i got some 17 inch egale alloys with low pro ZRi's , first i hooked up the system with a costom alpine cd player and an XM radio 2 10 inch pioneers 750 watts a pieace and a 500 watt kicker amp bout ive only had it 4 about 7 months im stil in the works im not sure what i want 2 do next. got any suggestions???
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 1/27/2006 10:31:37 AM
|
|
|
Thumpah
Posts: 4
Joined: 1/27/2006
Status: offline
|
Lookin' for ideas I'm thinking of squeezing a lil' more from the car to start I have 04' dodge stratus sxt 2.7 litre V6 3 speed auto trans. Looking for ideas on intake K & N makes a stock replacment however I haven't seen any true cold air intakers. Also lookin' to do cat back found everything for the coupe which is not a dodge motor mitsu makes the motor. also lowering preformance springs once again also for the coupe. any know of any good parts. One more thing chips for the ecm or a performance flash any takers on that. I've poken to a couple of master dodge techs and they say that there ain't much out there for the sedan. Help want more from this car looks good just want some good add ons!!!!!
|
|
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 2/9/2006 11:46:34 AM
|
|
|
Thumpah
Posts: 4
Joined: 1/27/2006
Status: offline
|
Thanks NowADodgeMan I like the headlights those give a great look I don't know if the lowering kit that you used would do me any good you have an SE model with basic suspension to start I have an SXT with sport suspension which already sits approx. 1/2 shorter than basic models
|
|
|
|
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 4/22/2006 12:07:18 AM
|
|
|
Ice_Man_67
Posts: 125
Joined: 7/3/2005
Status: offline
|
UPDATE!!!
Ok, I got a 95 SOHC 2.0L (5spd), with:
short thow shifter
cold air intake with K&N cone filter
Pacesetter header (ceramic coated) followed by custom 2.5" exhaust with hight flow cat and muffler
MSD coil and wires
NKG Iridium Spark Plugs
55mm bored out Throttle Body with half shaft mod (57mm)
AFX underdrive pulley
Canuck Lowering Springs 1.6" w/new struts all around
Performance Voltage Stabalizer
_____________________________
1995 Stratus 2.0L 5spd
CAI - w.K&N filter
2.5" exhaust
Magnaflow Cat/Muffler
MSD Coil and Wires
55mm throttle body
AFX underdrive pully
Short Throw Shifter
Canuck Lowering Springs 1.6"
Garrett T3 turbo w/7psi boost
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 4/29/2006 11:09:43 AM
|
|
|
slick_stratus
Posts: 14
Joined: 4/26/2006
Status: offline
|
hey im not gitting that check engine code but i am gitting many others....!!!! my map, maf,and tps, sensors are reading corralation at load.. and im gitting a high circut bank one sensor one error. i dont know what to do. i have replaced the map,map,and tps sensors and the check engin light never went off.. this is where it all started--------------------> i took off the cat converter and the car ran fine. ok. well about a week later i took off the throttlebody and bored it out but before i did that i undid my battery to reset the comp. i bored it out then hooked it back up. then the problems began. thats when i replaced all of that shit.... then i went and got 2 new o2 sensors check engin light still on! i went and got a dio done again i was gitting low circut bank 2 sensor 2 i know this wont make sence but hear me out. high circut bank2 sensor 2 ...... yeah.. so i bought a o2 simulator to simulate the cat converter to try to solve the problem and i got another dio done. i must of got like 25 dio's done by now... and i was reading low circut bank2 circut 2 so i fixed that and again went and got another dio done and now im gitting map, maf,and tps, sensors are reading corralation at load.. and im gitting a high circut bank one sensor one error and the car's rpm's wont let me go past 3500.. it bounces like the governor is stoping it when im swithching it from 1st to 2nd to 3rd and so on and when i stop or stay stedy on gas it bounces at 1000 rpms. and when on stoped it will try to cut out almost stalling then catch its self BOY IS THIS CAR PISSING ME OFF. PLEASE HELP CUZ PEOPLE IVE WENT TO DONT KNOW SHIT ABOUT MODDING CARS AND TELL ME WHAT I KNOW IT IS NOT....................
|
|
|
|
|
RE: Aftermarket product listing for the Stratus Sedan - 8/28/2006 1:48:17 AM
|
|
|
andrewjb2003
Posts: 30
Joined: 5/2/2006
Status: offline
|
quote:
ORIGINAL: NowADodgeMan
In the process of doing up my ride. 2004 SE Sedan w/ 2.7L V6
Here is what I have already or I am waiting to arrive and/or put on:
Crystal Headlight Assembly (found on ebay) w/ SilverStar Headlights and Sylvania clear corner bulbs.
Weapon-R Secret Weapon Cold Air Intake
18" Riax Zuku Wheels w/ 225/45/18 Toyo Proxies (found at rim1.com)
Roku Creations Muffler 2.5" inlet/2.5" outlet (found on ebay). Not installed.
Canuck Motorsports Lowering Springs (found on ebay) 1.6" drop front/rear. Not Installed
Areo Designs Body Kit (found on ebay). Not in possesion yet.
(Heard this Body Kit might not fit from other posts on this site, but roommate works w/ fiber glass and will modify for me.)
JVC Cheap Head unit from Wal-Mart
2 10" Infinity Basslink X preamped subs. Great interion sound, won't rock street.
If you want to check my ride, my album has pictures with rims. More pictures to follow.
Wal-mart is evil dont shop there
|
|
|
|
Contact Us |
Link To Us |
Sitemap |
Archive |
Advertising |
Automotive Directory |
About Us |
Dodge Links |
Legal |
Privacy Policy |
© Dodge Forum
Harley Davidson |
Ford Mustang Forums |
Dodge Challenger
Dodge Forum .com is not affiliated with or endorsed by Daimler Chrysler.
|
Printable Version
